Attaching The Blades - Casablanca Stealth Instructions Manual

Hide thumbs Also See for Stealth:

Owner's manual (17 pages)

Manual (16 pages)

Owner's manual and installation manual (2 pages)

Table Of Contents

Table of Contents

Step 3a. Attach the 5 blade tips to the blades using two

6-32x

⁄

" round head screws provided. Note: the screws

have locktite on them, so once they are installed it will

be difficult to remove the screws.

Step 3b. attach each of the five blades to the blade

holders using four of the truss head screws and fiber

washers provided for each blade. The truss head screw

is placed through the blade and then a fiber washer is

pressed on so that it is between the blade and blade

holder; see the detail drawing below. Hand tighten each

truss head screw firmly.

3b - BLADE INSTALLATION:

BLADE

TIP

Step 4. To hang the fan body in the canopy, support the

fan at the center of the glass holder and top support and

insert the ball into the canopy opening. Rotate the fan

body until the slot in the ball fits into the pin opposite the

canopy opening.

TOP SUPPORT

GLASS

HOLDER

INSIDE

CANOPY ELECTRICAL CONNECTORS

Step 5. attach the fan wires to the ceiling fixture outlet

box wiring by twisting the bare ends of the wires together

and securing with a wire nut. Connect in this order:

• GreeN leads from mounting plate and fan to

GrOUND conductor of power source. secure with

wire nut.

• WHITe wire from fan to white NeUTraL wire in ceiling

fixture outlet box. secure with wire nut.

• BLaCK wire from fan to black (or red) pOWer wire

in ceiling fixture outlet box. secure with wire nut.