Table of Contents
Advertisement
⑨ Trigger key
⑩ Output key
⑪ Number keys
⑫ Waveform
selection buttons
⑬ Power button
Rear Panel
①
20MHz reference
①
output
②
20MHz reference
input
③ External Trigger
/FSK/Burst
④ Modulation In
⑤ RS232 port
⑥ Power socket
⑦ Fuse
⑧ Power switch
4.Quick Start
In Sweep and N-Cycle Burst, if you choose Source as
"Manual", every time you press this key, the generator will be
triggered once.
Activate or deactivate the output signal
Input parameters, include: number, point and plus/minus sign
Include: Sine, Square, Ramp, Pulse, Noise and Arbitrary
waveform
Turn on/off the instrument
②
③
④
⑫
⑪
Figure 4-2 Rear panel overview
These two connectors are used to synchronize generators.
The connector [20MHz In] accepts an external 20 MHz
clock signal, and the connector [20MHz Out] can output a
20 MHz clock signal generated by the crystal inside the
generator. (See P35, "To Set the Clock Source")
This signal can be used as external signal source in Sweep,
FSK and Burst mode.
Modulation waveform input, use it as external signal source
Through this interface, the generator can be connected to a
PC and controlled via PC software.
AC input connector
Use the specified fuse according to the voltage scale.
Switch between 110V and 220V.
⑤
⑥
⑩
⑨
⑧
6
⑦
Advertisement
Table of Contents
