Table of Contents
Advertisement
(3) Remove the U disk: Remove the U disk from the USB Host port on the rear panel.
The system will inform you "The USB device is removed", and the "USBDEVICE" in
the storage menu will disappear.
To Edit the File Name
In file system, the user can edit the name of a file or a folder. When the system needs the
user to input a name, an input keyboard will appear.
(1) Turn the knob or press the ◄ / ► direction key to move the cursor left and right in
the keyboard; press the ▲ / ▼ direction key to move the cursor up and down. Press
F3 to switch between capital and small of the characters.
(2) Press F1 to enter the current character. Press F2 to delete the last character .
(3) Press
F4
to finish editing and save the file. Press
operation.
Note: The length of file name is up to 15 characters.
To Set the Utility Function
Press Utility function key to enter the Utility Menu. You can set the parameters of the
Generator such as: Display Parameter, Output Parameter, Interface Parameter and System
Setting. Press Utility again to exit the Utility Menu.
To Set Display Parameter
To Set the Bright
(1) Press Utility and choose Disp Setup, press F1 to select Bright.
(2) Turn the knob to change the value; or press the number keys to input the desired
value in percent, press F4 to select the unit. The bright range is 0%～100%.
To Set the Separator
The user can set the separator of the displayed parameter.
5.Front Panel Operation
Figure 5-22: Edit the File Name
30
F5
to cancel the save
Advertisement
Table of Contents
