⑨ LAN port
⑩ USB Host port
⑪ USB Device port
⑫ Digital output
User Interface
①
②
③
④
⑤
⑥
⑦
Figure 4-3 User interface (take Sine for instance)
① Parameter bar 1, display parameters and edit the focused parameter
② Load, High Z represents high resistance
③ Frequency/period, depends on the highlighted menu item on the right
④ Amplitude/high level, depends on the highlighted menu item on the right
⑤ Offset/low level, depends on the highlighted menu item on the right
⑥ Display current waveform
⑦ Parameter bar 2, display parameters and edit the focused parameter
⑧ Current signal type or mode
⑨ The setting menu of current signal or mode
⑩ Signal type
General Inspection
After you get a new AG4151 Waveform Generator, it is recommended that you should
4.Quick Start
Through this interface, the generator can be connected to
your local network and controlled via PC software.
Connect as a "host device" with an external USB device,
such as connect a USB disk to the instrument.
Connect as a "slave device" with an external device, such as
connected to a PC and controlled via PC software.
Connect the generator with the logic signal output module
(optional). Then, configure specific sequence digital signal
in the generator and output the signal through the digital
module.
7
⑧
⑨
⑩