Rear Panel - Owon XDS3204AE Manual

8. Copy button: You can save the waveform by just pressing this button in any user
interface.
9. USB Host port: It is used to transfer data when external USB equipment connects to
the oscilloscope regarded as "host device". For example: Saving the waveform to
USB flash disk needs to use this port.
10. Power on/off

Rear Panel

12
11
1. Handle
2. Air vents
3. Input terminals of multimeter (optional)
4. AC power input jack
5. Fuse
6. Foot stool: Adjust the tilt angle of the oscilloscope.
7. VGA port: To connect the oscilloscope with a monitor or a projector as VGA output
(optional).
8. LAN port: the network port which can be used to connect with PC.
9. USB Device port: It is used to transfer data when external USB equipment connects to
the oscilloscope regarded as "slave device". For example: to use this port when
connect PC to the oscilloscope by USB.
10. Lock Hole: You can lock the oscilloscope to a fixed location using the security lock
(please buy it yourself) to secure the oscilloscope.
11. Trig Out(P/F) port: Trigger signal output & Pass/Fail output, also can be used as the
port of CH2 Output of waveform generator (optional). The output type can be set on
the menu (Utility menu→Output→Output).
12. Out 1 port: CH1 Output of waveform generator (optional).
3.Quick Start
1
10
8
9
Figure 3-2 Rear Panel
5
2
7
3
4
5
6