Switch Lock - Craftsman 315.114520 Operator's Manual

SWITCH LOCK
See Figure 5,
The switch trigger can be locked In the OFF position. This
feature can be used to prevent the possibilityof accidental
starting when not In use. To lock switch tdgger, place the
directionof rotation selector (Forward/Reverse Selector)
in center position.
SELECTORWITH
CENTER LOCK POSITION
REVERSE
KEYLESS CHUCK
See Figure 6.
Yourdrillhas a le_ylesschuck,As me name implies,you can
hand tighten or releaseddl]bits in the chuckjaws. Graspand
ho4d the collarofthe chuckwith one hand.Rotate the chuck
bodywithyourother hand.The an-owson the chuck
Indicate whichdirection to rotatethe chuck bodyIn orderto
LOCK (tighten) or UNLOCK (release) the drillb_t.
DRILLBIT
UNLOCK CHUCK
(RELEASE) COLLAR
SWITCH
FORWARD TRIGQER
Fig. 5
WARNING: Battery tools are always In operating
condition. Therefore, switch should always be locked
when not In use or carrying at your side.
REVERSIBLE
See F/gum 5.
This tool has the feature of being reversible. The direction
of rotation is controlled by a se]ector located above the
switch trigger. With the drill held In normal operating
position, the direction of rotation selector should be
positioned to the left of the switch for drilling. The drilling
direction is reversed when the selector is to the right of
the switch. When the selector is in center position, the
switch trigger is locked.
_k CAUTION: To prevent gear damage, always al]ow
chuck to come to a complete stop before changing
the directionof rotation.
To stop, release switch trigger and allow the chuck to come
to a complete stop.
CHUCKJAWS
LOCK CHUCK
mGHTE_ BODY
FIg. 6
_lb WARNING : Do not hold chuck body with one hand
and use powerof the drillto tightenchuck Jaws on
drillbit. Chuck body could slip In your hand or your
hand could slipand come in contact with rotatingdrill
bit. This could cause an accidentresulting in sedous
personal Injury.
12