Table of Contents
Advertisement
SWITCH LOCK
See Figure 5.
The switch trigger can be locked in the OFF position. This
feature can be used to prevent the possibility of accidental
ctarting when not In use, To lock switch trigger, place the
direction of rotation selector (Forward/Reverse
Selector)
in center position. Note: When selector is in center
position, switch trigger is locked.
SELECTORWITH
CENTER LOCK POSITION
REVERSE
KEYLESS CHUCK
See Figure 6.
Your drill has a keyless chuck. As the name implies, you can
hand tighten c_ release ddllbits In the chuck jaws. Grasp and
hold the collar of the chuck with one hand, Rotate the chuck
body with your other hand, The arrows on the chuck
Indicate which diroctlen to rotate the chuck body in order to
LOCK (tighten) or UNLOCK (release} the drill bit.
DRILL B4T
UNLOCK
CHUCK
(RELEASE)
COLLAR
SWITCH
TRIGGER
FORWARD
Fig. 5
,_k
WARNING:
Battery tools are always in operating
condition. Therefore,
switch should always be locked
when not in use or carrying
at your side.
REVERSIBLE
See Figure 5.
This tool has the feature of being reversible.
The direction
of rotation is controlled
by a selector located above the
switch tdgger. With the drill held In normal operating
position, the direction
of ro_ation selector should be
positioned
to the left of the switch for drilling. The ddlllng
direction is reversed when the selector is to the right of
the switch. When the selector is In canter position, the
switch tdgger Is locked.
CAUTION:
To prevent gear damage, always allow
chuck to come to a complete stop before changing
the direction
of rotation.
To stop, release switch trigger and allow the chuck to come
to a complete
stop.
CHUCK JAWS
LOCK
CHUCK
(TIGHTEN)
BODY
Fig. 6
_kWAR
N ING: Do not hold chuck body with one hand
and use power of the drill to tighten chuck jaws on
drill bit. Chuck body could slip in your hand or your
hand could slip and come in contact with rotating drill
bit. This could cause an accident resulting in sedous
personal Injury.
11
Advertisement
Table of Contents
