Theswitch trigger c anbelocked intheOFFposition. This
feature conbeused toprevent thepossibility of
staEing when not in use. To lock switch trigger, place the
direction of rotation seh;ctor
in center position
8arrery tools are always in operating
switch should always be locked
when not in use or carryir]g at your side.
See Figure 5.
This tool has the feature of being reversible.
o'f rotation is controlled
by a selector located above the
switch trigger. With the ddll held in normal operating
position, the direction of rotation selector should be
le the lef: of the switch for drilling. The drilling
direction is reversed when the selector is to the right of
the switch. When tt_e selector
is in center position, the
switch trigger is locked.
CAUTION: To prevent gear damage, always allow
chuck to come to a complete stop before changing
the direc'rion of rotation
To stop, release switch trigger and allow the chuck to come
to a complete
See Figure 6.
Your drill has a keyless chuck. As the name implies, you can
hand tighten or release dnll bits in the chuck iaws. Grasp and
hold the cellar of the chuck with one hand. Rotate the c_huck
body with your other hand. The arrows on the! chuck
indi_-qte which direction to rotate the chuck body in oraer to
LOCK (tighten) or UNLOCK
(release) the dnfl bit
Do not hold chuck body with one hand
and use power of the drill to tighten chuck jaws erl
drill bit. Chuck body could slip in your hand or your
hand could slip and come in contact with rotating drili
bit. This could cause an accident resulting in serious