DRILL-DRIVER
Chuck
Motor
Gear Train
Switch
No Load Speed
Clutch
Maximum Torque
CHARGING
ASSEMBLY
Rating
Charging Voltage
Charge Rate
BATTERY
PACK
315.114520
3/8 In. Keyless
DC Motor 12 Volt
Two Speed
Variable Speed
0-300 RPM (Low)
O-1000 RPM (High)
24 Positions
225 In,lb.
Item No. =11055
(1425004)
1 20 V, 60 Hz, AC only
12 Volt
3-6 Hours
Item No. !11057
(1322549)
315.114530
3/8 in. Keyless
DC Motor 14.4 Volt
Two Speed
Vadabls Speed
0-400 RPM (Low)
0-1400 RPM (High)
24 PoslUons
275 In,lb.
Item No. !11041
(1425301)
120 V, 60 Hz, AC only
14.4 Volt
1 Hour
Item No. !11044
(1322522)
• Craftsman
EX 114520 - 12V test criteda
225
In,]b. torque
280
#5 x 1,25 in, wood screws In low speed per battery pack charge Into pine lumber.
150
3/8 In. diameter holes par battery pack charge into 2 in. nominal pine lumber,
Craftsman
EX 114530 - 14.4V test criteria
275
I
in,lb. torque
220
I
#8 x 1.25 in. wood screws In low speed per battery pack charge Into pine lumber,
170
3/8 In, diameter
holes per battery peck cherge Into 2 In. nominal pine lumber.
KNOW YOUR DRILL-DRIVER
See Figure 1.
Before attempting to use your drill-driver,familiarize
yourselfwith all operating features and safety
requirements.
KEYLESS CHUCK
Your drill-driver h as a keylesschuck that allowsyou to hand
tighten or release drillbit Inthe chuckjaws,
SWITCH
To turn your drill-driverON, depressthe switchtrigger,
Release switchtriggerto turn your drill-driverOFF.
SWITCH LOCK
The switch trigger nan be lockedin the OFF position.This
feature helps reduce the possibility of accidental starting
when not In use,
VARIABLE
SPEED
This tool has a variab[e speed switch that delivers higher
speed with Increased tdgger pressure. Speed is controlled
by the amount of switch trigger depression.
TWO SPEED
GEAR
TRAIN
Your drill-driver has a two speed gear train designed for
drilling or driving at HI or LO speeds. A slide switch is
located on top of your drill to select either HI or LO speed,
FORWARD/REVERSE
SELECTOR
(DIRECTION OF ROTATION SELECTOR)
Yourdrill-driverhas a forward/reverseselectorlocated
above the switch trigger.
WRIST STRAP
A wrist strap is provided to reducethe chances of dropping
your dril!-driver,Place one handthrough the wdststrap
when carryingtool.
BIT STORAGE
When not In use, bit(s) providedwith your drill-drivercan
be placed In the storage area located on the bottomof the
motor housing.
LEVEL
To keep drill bit level duringddlllngoperations,a level Is
locatedon the back of the motorhousing.
,_
WARNING: ff any partsate missing,do not operate
yourdrill-driver until the missingpartsare replaced.
Failureto do so couldresultIn possiblessdous
personal Injury.
Need help?
Do you have a question about the 315.114520 and is the answer not in the manual?
Questions and answers