Battery Pack - Craftsman 315.114520 Operator's Manual

_ WARNING : Always wear safety gogglesor safety
glasses with side shields when operatingtools.
Failure to do so could result In objects being thrown
intoyour eyes, resultingin possible sedousinjury,
_ WARNING: 0o not allow famillahtywith yourdrilL-
driver to make you careless, Remember thet a
careless fraction of a second Is suffic[ertto inflict
severe injury,
BATTERY PACK
(MODEL 315.114520)
The battery pack for your tool has been shipped in alow
charge condition to prevent possible problems.
Therefore, you should charge It overnight prior to use,
Note; Batteries will not reach full charge the firs[ time they
are charged, Allow several cycles (drilling followed by
recharging) for them to become fully charged,
CHARGING BATTERY PACK
(MODEL 315.114520)
See Figure 1.
• Charge battery pack only with the charging assembly
provided.
• Make sure power supply Is normal household
voltage, 120 voits, 60 Hz, AC only.
• Connect charger to power supply,
• Place battery pack in charging stand, Align raised fib
on battery packwlth groove [n charging stand.
See Figure 1.
• Press down on batte_ pack to be sure contacts on
battery pack engage properly with contacts In charg]ng
stand.
The charge Indicator light (LED), located on the
charging stand, will light up red and glow when the
charger is properly connected to power supply. This
light Indicates the charger is operating properly, It w]ll
remain on until battery pack Is removed from charging
stand or charger is disconnected from power supply,
• Note: If charger does not charge battery pack, return
battery pack and charging assembly to your nearest
Sears Repair Center for electrical check.
• After normal usage, a 3 hours or less of charging time
Is required to fully recharge battery pack, Note: If
battery pack Iscompletely discharged, 6 hours or
longer of charging time Is required to fully recharge
battery pack,
• The battery pack wl[I become slightly warm to the
touch while charging. This is norn'_l and does not
Indicate a problem,
• 0o not place charger in an area of extreme heat or
cold, It will work best at normal room temperature,
• When batteries become lully charged, unplug charger
from power supply and remove the battery pack.
IMPORTANT INFORMATION FOR RECHARGING
HOT BATTERIES
(MO DEL 315.114520)
When usLng your drill-driver continuously, the batteries in
your battery pack will become hot. You should let a hot
battery pack cool down for approximately 30 minUtes
before attempting to recharge.
Note: This situation only occurs when continuous use of
your drill causes the batteries to become hot. It does nat
occur under normal circumstances. Refer to "CHARGING
BATTERY PACK" for normal recherglng of parterres. If
the ch_ging assembly does nat charge your battery pack
under normal circumstances, return both the battery pack
and charging assembly to your nearest Sears repair
center for electrical check.