Mounting The Motor - Craftsman Contractor 113.29884 Owner's Manual

MOUNTING THE MOTOR
1. From among the loose parts, find the following
hardware:
4 Carriage Bolts, 5/16-18 x 3/4 in. long
4 Hex Nuts, 5/16-18 (approx. dia. of hole 5/16 in.)
4 Lockwashers, 5/16 in. External Type (approx.
dia. of hole 5/16 in.)
1 Cast Iron Motor Pulley
CARRIAGE
BOLT
5/16" EXTERNAL
LOCKWASHER
G
5/16" HEX NUT
MOTOR PULLEY
2. The motor base is installed in the cradle for shipment.
Pull the motor base away from the cradle and put it
on the floor before mounting the motor to it.
3. Place motor on MOTOR BASE.., insert bolts through
holes in MOTOR BASE...then through the motor
MOUNTING BASE. Install Iockwashers and nuts,
4. Position motor so that edge of MOTOR MOUNTING
BASE and MOTOR BASE are even as illustrated...
slide motor all the way to the RIGHT...tighten the
four nuts,
5, Loosen set screw in motor pulley using 5/32 in, Hex
"L" wrench. Slide pulley onto shaft with HUB away
from motor. DO NOT TIGHTEN SET SCREW.
6. Install 3/16 in. square key (furnished with motor) in
grooves in pulley and motor shaft. DONOT TIGHTEN
SET SCREW,
KEY PULLEY
7. Lift motor and insert the TWO PINS on motor oase
into HOLES IN cradle.,,push motor in as far as it
will go.
32