Motor Connections; Plugging In Motor - Craftsman Contractor 113.29884 Owner's Manual

MOTOR CONNECTIONS
WARNING: For your own safety, never connect
plug to power source out_et until a_ assembly
steps are compgeted.
1. Open motor connector box cover 8ocated on side of
motor using a fiat blade screwdriver.
WARNING: To avoid eiectrocutlon, never con-
nect anythlng but the ground wire (colored
green} _o the green screw.
2. Remove GREEN SCREW and insert through round
metalterrninal on the end ofthe GREEN wire of power
cord.
3. Reinserl GR EEN SCREW inthreaded hole that itwas
removed from and tighten securely.
4. Insert terminal end of BLACK wire on spade terminaa
next to copper post on the motor. Pushterminalfirmly
until seated.
5. Insert termina_ end of WHITE wire on spade terminal
next to silver post on the motor. Push terminal firmly
until seated.
6. Close motor connector box being sure that power
cord is seated in strain relief groove and tighten box
cover screws.
7. Do not plug in power cable.
BLACK WIRE TO SPADE
TERMINAL BESIDE
COPPER POST
GREEN WIRE
TO GREEN SCREW
STRAIN RELIEF
GROOVE (BOTTOM)
WHITE WIRE TO SPADE
TERMINAL BESIDE
;ILVER POST
PLUGGING iN MOTOR
1. From among the loose parts, find:
2 Wire Ties
2. Route motorcord along right sideof cabinet and
snap ties n 1/4" hole in side of cabinet. Secure
_wo cords n wire ties,
EXTENSION REMOVED FOR
PICTURE CLARITY
WIRE TIES
35