Mounting The Motor; Installing Pulley - Craftsman 113.299315 Owner's Manual

Assembly (continued)
4_ Place rip fence on the right hand side of table. Care-
fully move it against blade so that it is parallel to the
blade, and just touches tips of saw teeth. Tighten rip
fence lock lever.
5. Insert folded paper between spreader and fence.
6. Using 7/16 wrench loosen the 1/4-20 hex head screws
so the spreader can slide sideways.
7. Hold spreader flat against fence, Tighten screws using
7/16 inch wrench.
8. To remove blade guard and spreader, loosen thumb-
screw. Do not loosen other screws. This allows you
to remove and replace the guard for non-through cuts
without disturbing the spreader alignment.
FoBded Paper
7116 In.
Wrench \
Head Screw
Mounting the Motor
1. From the bag labeled "Motor, Guard.Base" remove
only the following hardware:
*4 Carriage Bolts, 5/16-18 x3/4
*4 Hex Nuts, 5/16-18
*4 Lockwashers, 5/16 ExtemalType
From the bag labeled "Large Parts" find the following:
1 Motor pulley
1 Belt
From among the loose parts find the following:
1 Motor
1 Motor Support Assembly
Items marked with an asterisk (*) are shown actual
size.
2. Align holes in motor base and motor support assem-
bly. Insert carriage bolts through holes in motor su p-
port assembly then through the motor base. Install
Iockwashers and nuts hand tight.
3. Position motor so that the top edge of motor base and
motor support assembly are even as illustrated Center
motor side to side on motor support assembly. Tighten
the four nuts.
5116-18 x 314
Carriage Bolt
5116-18
Hex Nut
Motor Pulley
Motor Support
Assembly
Hex Nut Lockwasher Align Top
\ Edges
O
5116 in. External
Lockwasher
Motor
Carriage Bolt
Installing Pulley
1. Loosen set screw in motor pulley using 5/32 in.hex "L"
wrench. Slide pulley onto shaft with hub away from
motor. Do not tighten set screw.
2. Install 3/16 in. square key (furnished with motor) in
grooves in pulley and motor shaft. Do not tighten set
screw.
Motor
Motor Support
Assembly
Center Motor
Side to Side
3/16Square
Motor Pulley /
24