Mounting The Motor - Craftsman 113.248212 Owner's Manual

BOTH MODELS
MOUNTING THE MOTOR
1, Find
ITEM
A
B
C
D
E
F
G
H
i
the following parts:
DESCRIPTION QTY.
Motor .......................................................................... 1
Spacer (#10 x 1/4) .................................................. 3
Flanged Locknut #10-32 ............................................... 4
Wing Nut 5/16-18 ............................................................. 1
Motor Pulley w/Set Screw
(Model ! 13,,248322) .................................................... 1
Belt Tension Stud ....................................................... 1
Motor Pulley w/Set Screw
(Model 113248212 ....................................... t
Poly "V" Belt ............................................................. 1
Key 3/16 Sq. x 15/16 ......................................................... 1
A-,t-
*NOT SHOWN TO SCALE
5PACER
2, Place the three (3) spacers onto the three motor studs
as shown, Pay attention to where the oil plug is
located,, no spacer goes on the fourth motor stud..
OIL PLUG
I
MODEL 113.248212 ONLY
3 Locate the correct motor pulley (has no step), Place
the shaft key into the groove on the motor shaft Align
the groove in the pulley with the shaft key and install
the motor pulley onto the motor shaft with the set
screw boss toward the motor,. Position the outer face of
the pulley w inches from the end shield of the motor
and tighten the set screw using a 1/8-inch hex "L"
wrench,
MODI tL t13.288322 ONLY
4, Locate the correct motor pulley (Model 113248212
has "one-step" pulley),, Place the shaft key into the
groove on the motor shaft, Align the groove in the pul-
ley with the shaft key and install the motor pulley on the
motor shaft with the setscrew boss toward the motor.,
14