Mounting Switch; Guide Bar - Craftsman Contractor 113.29884 Owner's Manual

MOUNTING SWITCH
1, From among loose parts find the following:
2 Hex Head Screws, 5/16-18 x 5/8 in. long
2 External 5/!6" Lockwashers
2 Hex Nuts, 5/t6-18
5/8 IN 5/t6 IN EXTERNAL 5/16 IN
HEX HD SCREW LOCKWASHER HEX NUT
2. Select one front fence guide bar.
3. insert two 5/8 inch screws through holes in switch.
4. Insert screws through fourth and fifth holes in front
fence guide bar as illustrated.
5. _nstall two Iockwashers and nuts. Tighten nuts.
i
JAM NUT
5/16-18
,]
,_, _Q/LOCKWASHER
4TH HOLE ! " 5TH HOLE
= = "_=. • .== =----,_
%
FRONT FENCE \_\
GUIDE BAR "_
(UPSIDE DOWN) _ _
HEX HEAD SCREW
5/1 18 x 5/8iN.
iNSTALLiNG RIGHT FRONT RiP FENCE
GUIDE BAR
1. From among the loose parts find the following
hardware:
2 Hex Head Screws, 5/16-18 x 1-1/2 in. long
1 Hex Head Screw, 5/16-18 x 1-1/4 in. long
2 Hex Head Screws, 5/16-18 x 3/4 in. long
5 External Lockwashers, 5/16 in. (approx. dia. of
hole 5/16 in.)
5 Hex Nuts, 5/16-18 (approx. dia. of hole 5/t6 in.)
3 Spacers, 3/4 in. dia. x 1/2 in. long
5 Washers (dia. of hole 21/64 in.)
1 Front Fence Guide Bar (with switch attached)
2 Brackets
1-1/2 IN HEX HD. SCREW
1-1/4 IN HEX HD. SCREW
3/4 IN HEX HD.
SCREW
1/2 IN SPACER
21/64 iN WASHER
5/16 IN EXTERNAL 5/16 IN
LOCK WASHER HEX NUT
BRACKET
FENCE GUIDE BAR
WITH SWITCH
2. Put one of the brackets against the right edge of the
right extension so the bracket is lined up with the
FIRST hole near the front of the extension. Insert a
3/4 inch long screw through a flat washer, through
top hote in the bracket, and through the FIRST hole
in the extension, install a Iockwasher and nut on the
screw. Tighten the nut only slightly.
3. Install the other bracket against the left side of
left extension-using the same procedure explain-
ed above.
17
HEX NUT
EXTERNAL
LOCKWASHER HEX HEAD
SCREW
5/16-18 x 3/4 iN