Repetitive Cutting - Craftsman Contractor 113.29884 Owner's Manual

When cutting long workpieces, invert AUXILIARY FENCE/
WORK SUPPORT and Position it on top of the guide bars
to support the workpiece as near to the end as possible.
if this does not adequately support the workp_ece, _,ou
can make a simple support by clamping a piece of ply-
wood to a sawhorse. See 1st illustration under "Cross-
cutting."
Use the Hold-Down Clamp (Optional Accessory) on
the miter gauge for greater accuracy.
AUXILIARY PANEL/
WORK SUPPORT
\
\
REPETITIVE CUTTING
REPETITIVE CUTTING is known as cutting a
quantityof pieces the same length without having to
mark each piece,
1. Use the Stop Rods (optional accessory) only for
cutting duplicate pieces 6 in. long and longer.
2. Follow al safety precautions and operational
instructions for cross cutting.
When making repetitivecuts I rom a long workpiece.
make sure it is adequately supported.
Use the Hold-Down Clamp (Optional Accessory) on
the miter gauge for greater accuracy.
LEFT HAND [REMOVED
FOR PICTURE CLARITY
STOP RODS ,, "
44