Checking Table Insed - Craftsman Contractor 113.29884 Owner's Manual

ASSEMBLY
Before mounting the saw on legs or a stand or a bench,
the Table Insert and Blade Squareness must be checked
at this time.
UNSTALLING HANDWHEELS
1. Slide theelevation handwheel onto itsshaft. Line
up the fiat spot on the shaft with the set screw in
the handwheeL Using a hex "L" wrench - tighten
the set screw securely against the flat spot on the
shaft. Repeat this same procedure to install the
tilt handwheel.
ELEVATION
HANDWHEEI
TILT HANDWHEEEL
J WARNING: To avoid injury from accideltlai start,
make sure switch is "OFF" and plug is not con-
nected to power source ouUet.
CHECKING TABLE iNSERT
!. Insert should be flush with table top. Check as shown.
Loosen flat head screw that holds insert and adjust
the four set screws as necessary. Tighten flat head
screw. Do not tighten screw to the point where it
deflects the insert.
CAUTION: Insert must be even with the table I
surface, inserts too high or low can let the I
workplece "snag" or catch on uneven edges. ]
Workplece could twist and kick back°
3/32 IN.
SET SCREW WRENCH
2. To remove insert.
A. Make sure saw is off and unplugged.
B. Loosen screw.
C. Lift Insert from front end, and pufftoward front of
saw.
3. To replace Insert.
A. Make sure saw is off and unplugged.
B. Place Insert into insert opening in table arid push
toward rear of saw to engage spring clip and urltil
keyslot in Insert will drop over screw. Tighten
screw,
C. Do not tighten screw to the point where it wifl
deflect the Insert.
\
PHILLIPS
FLAT HEAD
_-- SCREW
13