Craftsman Contractor 113.29884 Owner's Manual page 27

mNSTALLmNG MEASURING TAPES
1. From the !oose parts find:
2 Measuring Tapes
-"-:- - ...... _ + 4 _ ÷:-÷-4-_t=::T:=F._T-_-_
2. Place rip fence on saw table to the right side of
the blade.
3. Using a tape ruie measure six inches out from the
right side of the btade. Position the rip fence so
the left side of the fence is at this six inch mark.
4. Lock the fence in this position.
)
5. Find the "0" inch mark on the end of one of the
measuring tapes, Slide this end of the measuring
tape under right side of rip fence head and push
tape along top surface of rip fence guide bar.
6. Move measuring tape under plastic window of rip
fence head until six inch mark on measuring tape
is straight under red line (pointer) on the plastic
window.
7. Hold measuring tape in this position and draw a
pencil mark across rip fence guide bar at left en0
of measuring tape,
6"MARK
27