Craftsman Contractor 113.29884 Owner's Manual page 34

2. Remove the belt and motor pulley.
3. Screwsfurnished with guard are"self-threading"
screw them into holes in BELT GUARD
SUPPORT BRACKET to cut threads, then remove
them.
4 Position BELT GUARD SUPPORT BRACKET
and BELT GUARD SUPPORT as shown and
install the screws., make sure motor shaft is in
CENTER of hole in SUPPORT.
BELT GUARD
PPORT BRACKET
BELT GUARD 10-32 x 112 IN.
SUPPORT SELF-THREADING
SCREW
5. install three CLIPS (furnished with guard) 90 °
apart starting with one clip at the end of the
guard asshown_ .. LONG END of clip must be on
outside of guard pointing away from opening in
guard,
OPENING
/
BELT GUARD \, _ _,'__'_f!_ CLIPS
X
LONG END
6. Reinstall motor pulley the same way it was when
you aligned the belt
7 Place belt on SAW PULLEY. insert end of belt
through opening in END of guard
8. Lift motor and slip belt over motor pulley
BELT
9. Press guard onto support so that bottom of
guard is approximately 3/4 in. away from belt.
NOTE: To remove guard, lift up on LONG TABS
of clips.., pull guard outward. The clips should
remain on the BELT GUARD SUPPORT.
34
1
I
3/4 IN.