Attaching And Assembling Table Extensions - Craftsman Contractor 113.29884 Owner's Manual

ATTACHING AND ASSEMBLING
TABLE EXTENSIONS
From among the loose parts find the following
hardware: (Quantity indicated is for 2 extensions)
Description Qty.
Hex Hal. Screw 5/16-18 x 1-1/4 ...... 8
Flat Washer (Dia of Hole 11/32) ..... 8
External Lockwasher 5/16 ........... 8
Hex Nut, 5/16-18 .................... 8
1. Insert four (4) 5/16-18 x 1-1/4 in. long screws
through holes in each EXTEN SION.
2. Position an extension against table so screws
extend th rough holes in table.
3. Install flat washer, Iockwashers, and nuts on the
screws, ,. DO NOT TIGHTEN,
HEY, HEAD SCREW
FLAT WASHER
5/16 IN HEX NUT
5/16 IN EX-FERNAL
/
/ \--1 "- -
"_<L -- SAW TABLE
HEX HD. SCREW _G
> (REF}
FLAT WASHER // / '"
EXTERNAL HEX NUT
LOCKWASHER
4. Une up rearedge of extension with rear edge oftable.
Line up top surface of extension with top surface of
table at the locations indicated by the "X's" (see
illustration).
Use a combination square to line up these edges and
surfaces. Slightly tighten nuts with a 1/2" wrench.
5. If adjustment is necessary you should tap the
extension into position using a hammer and a
block of wood. Make surerear edge of exten sion
is lined up with rear edge of tab{e. Then firmly
tighten nuts
6. Repeat the same procedure to install the other
extension.
BLOCK OF WOOD
CHECK WITH SQUARE
AT 2 PLACES
MARKED WITH "X"
16