Table of Contents
Advertisement
Fig. 63 - Pan Head Screw
5. Attach
the doors to the hinges on the side
panels
using eight plastite
screws. Tighten
with a Phillips screwdriver.
(Figure
64)
Fig. 64 - Plastite Screw
Attaching
Handwheel
Both Models
1. Place the handwheel
on the front of the
saw. The front of the saw has a D-shaft that
fits into a D-slot in the handwheeI.
2. Attach the handwheel
using a screw and ex-
ternal lockwasher.
(Figures
65 & 66)
Mounting the Motor
Both Models
_lh WARNING:
Plugging
the saw in
during assembly
can result in electrical
shock
or your fingers,
hand, or arm
being cut off from
blade
contact.
Do not
plug in the saw at any time during
as-
sembly.
The saw should
only be
plugged
in when it is to be used.
1. Loosen
the guard clamp screw and remove
the guard from the motor.
2. Use the arbor wrenches
to remove
the
blade from the saw. The arbor shaft has left-
handed
threads,
so you will have to turn the
nut clockwise
to loosen.
3. Lock the rip lock.
4. Raise the radial arm about 2 inches and
remove
the styrofoam
packing
blocks.
5. Clean
the small pieces
of styrofoam
off the
saw.
6. Place the motor on the center
channel
of
the saw and remove
the three
table boards
and fence.
7. Remove
the lock nut and flat washer
from
the motorpivot
support.
(Figure
67)
\
Bevel Encoder
Motor Pivot
Support
Fig. 65
Motor
Fig. 66 - Screw and External Lockwasher
25
Hide quick links:
Advertisement
Table of Contents
