Mounting The Motor - Craftsman 113.247410 Owner's Manual

MOUNTING THE MOTOR
1. Find the following parts:
ITEM DESCRIPTION QTY.
AA Motor ................................. 1
J Spacer (1/40.D. x 5/16) ............... 3
K Flanged Locknut #10-32 ............... 4
M Wing Nut 5/16-18 ...................... 1
U Belt Tension Stud .......... ........... 1
W Motor Pulleyw/Setscrew ............... 1
V Poly"V" Belt .......................... 1
X Shaft Key 3/16 ........................ 1
*NOT SHOWN TO SCALE
2. Have the band saw positioned on its left side as
unpacked. To prevent scratching the finish, lay a
piece of the packing box under the saw.
3. Place the three (3) spacers onto the three motor
studs as shown. Pay attention to where the oil
plug is located. No spacer goes on the fourth
motor stud.
4. Place the shaft key into the groove on the motor
shaft. Align the groove in the pulley with the shaft
key and install the motor pulley on the motor
shaft with the setscrew boss toward the motor.
The pulley has an internal shoulder that will
position the pulley the correct distance on the
motor shaft.
5. Place the Poly "V" belt into the motor mount as
shown on the underside of the band saw.
6. Look at the motor mount and find the slot that is
narrower than the other three. When mounting
the motor, the motor stud without a spacer goes
into this slot.
MOTOR %IOUN _ /
SLOT
12