Installing Left Front Rip Fence; Guide Bar - Craftsman Contractor 113.29884 Owner's Manual

6TH HOLE SPACER
4. Insert a 1-114 inch long screw through a flat washer _-'_-_, -_._t_--_ _,z
and the SECOND hole IN THE FRONT BAR as illus- _-_ _ "%'--- ,_:_!'_ _"_"_
trated, insert a 1-I/4 nch ong screw throuah a washer "_,_;_ _ - _';v_"" @_
and through the SIXTH hole in bar. nsert another 1-1I " _ _ ", ; ;itS%,. /,
•
',,y3_'_ _'1 _- - ...... / , ,_ _':
2 Inch long screw through a flat washer and through _ ..... & ,SHE i,_ /
-" -J _ ,HEX HEAD
the NINTH hold in bar. / _" .-, [
Place p ce,s on screws \
HEX HEAD SCREW "N-_.
5/16-18 X 1-114 y"
6. Turn front bar end for end and insert two screws
through hoaes in right tront edge of table. The third
screw is inserted through the elongated slot in the
bracket you installed earlier. Instafl Iockwashers and
nuts. DON'TSCREW NUTS ON ALL THE WAY, just
get them started on the screws.
iNSTALLiNG LEFT FRONT RiP FENCE
GUIDE BAR
1. From among the loose parts find the following
hardware:
2 Hex Head Screws. 5/16-18 x 1-1/2 in. long
1 Hex Head Screw, 5/16-18 x 1-1/4 in_ long
3 External Lockwashers 5/16 in.
3 Hex Nuts. 5/16-18
3 Flat Washers {dia. of hole 21/64 in.)
3 Spacers, 3/4 in. dia. x 1/2 long
1 Front Fence Guide Bar
1-1/2 IN HEX HEAD SCREW
5/16 IN EXTERNAL
WASHER __)
1-1/4 tNHEXHEADSCREW _ _,J ]
5/t6-18
HEXNUT
FLAT WASHER
1/2 IN SPACER
L-_--_ ............................ _-_
FRONT FENCE GUIDE BAR
•
2ND HOLE SPAC_ER
......
6TH HOLE
2. Lay gu de bar on saw table as illustrated SPACER / ......... _" _'-
3. Insert a !-1'2 inch long screw through a flat washer _L_I_ "_" s;--z::.-:__'_"_1-
and then through the FIRST hole in the bar as illus-
.. _
trated Insert a 1-112 _nch long screw through a flat ,_,-u,-,LE_._ --_._=_,._:_--, <-.... _ _:.,,
washer and then through the SECOND hole in bar. _",_:¢'_.,r_'_ ./". ._'X,
. ,_,L.-:_---.. "_-_ .._c-_ ...... - _ \
Insert another 1:1t4 ,nch tong screw through a flat WASHER-_i '-_" -- - -
.... ' HEX HEAD SCREW
washer and then through the SIXTH hole in bar.
HEX HEAD SCREW J- 5/16-18 X 1-1/4 _N
4. Place spacers over threaded end of screw as illus- 5/16-18 X 1-1/2 IN
....
trated. / , _ . .
/
18