Setting Up Ups Load Segment Control - Dell PowerEdge UPS 500T Installation And Configuration Manual

To reset the sensor values:
1 Select the check box for the options to reset:
• Reset Peak Consumption Watts
• Reset Cumulative Consumption Watts
• Reset Peak Headroom Watts
2 Click OK.
The sensor values clear, and the date and time stamp for the statistic resets to the current date and
time.

Setting up UPS Load Segment Control

The Load Segment Control window contains parameters to control each UPS load segment. Select Load
Segment Control from the UPS menu to open the Load Segment Control window (see Figure 60).
NOTE:
If the UPS Control Commands from Serial Port setting is disabled, configuration and load control commands
are restricted to the LCD only. This setting must be enabled from the LCD before you can select Load Segment
Control.
Figure 60. Load Segment Control Window
Configuring the Software
59