3. Enter the SNMP Community String.
NOTE: Be sure to note the community string, because it must match the SNMP Trap community string which is configured later in
this document.
Figure 2
4. Enter the required fields for configuration and basic monitoring:
Telnet/SSH Username
Telnet/SSH Password
"enable" Password
5. Enter the required fields for WMS Offload:
SNMPv3 Auth Protocol
SNMPv3 Privacy Protocol
SNMPv3 Username
Auth Password
Privacy Password
NOTE: The protocols should be SHA and DES in order for WMS Offload to work.
6. When finished, select Save.
Setting Up Recommended Timeout and Retries
To set recommended timeout and retries settings, follow these steps:
1. In the Device Setup > Communication page, locate the SNMP Setting section.
2. Change SNMP Timeout setting to 10.
3. Change SNMP Retries to 1.
Figure 3
4. Select Save.
10 | Configuring AirWave for Global Dell PowerConnect W-Series Infrastructure
Dell PowerConnect W Credentials in Device Setup > Communication
Timeout settings in Device Setup > Communication
Dell PowerConnect W-AirWave | Version 7.3