Dell PowerEdge UPS 500T Installation And Configuration Manual page 75

6 Click OK to save and exit.
NOTE:
If the UPS Control Commands from Serial Port setting is disabled, configuration and load control
commands are restricted to the LCD only. A read-only access message displays when you click OK
(see Figure 76). You must enable this setting from the LCD before you can apply changes to the UPS Self-Test
window.
Figure 76. UPS is Set to Read-Only Message
The UPS Test Manager window displays the task with a blue dot on the scheduled day and lists the
detailed information in the task list (see Figure 77).
Figure 77. UPS Test Manager Window
Configuring the Software
75