Licensing And Dependencies In Aruba Configuration; Setting Up Initial Aruba Configuration; Prerequisites; Procedure - Dell PowerConnect W-Airwave Configuration Manual

1. You can review the AOS running configuration file. This is configuration information that AWMS reads
from the device. In template-based configuration, you can review the running configuration file when
working on a related template.
2. You can use the
3. Once you audit your controller, you can click
the profiles on the controller.

Licensing and Dependencies in Aruba Configuration

You can review your current licensing status with the
AWMS requires that you have a policy enforcement firewall license always installed on all Aruba
controllers. If you push a policy to a controller without this license, a
and the controller will show as
Aruba Configuration includes several settings or functions that are dependent on special licenses. The user
interface conveys that a special license is required for any such setting, function, or profile. AWMS does not
push such configurations when a license related to those configurations is unavailable. For details on the
licenses required by a specific version of ArubaOS, refer to the ArubaOS User Guide for that release.

Setting Up Initial Aruba Configuration

This section describes how to deploy an initial setup of Aruba Configuration in AWMS 6.4 or later versions.

Prerequisites

Complete the AWMS upgrade to AWMS 6.4 or later. Refer to
installation or upgrade documents. Upon upgrade to AWMS Version 6.4 or later, Aruba Configuration is
enabled by default in groups with devices in monitor-only mode and AOS firmware of 3.3.2.10 or greater.
Back up your ArubaOS controller configuration file. Information about backing AWMS is available in the
AWMS User Guide in the "Performing Daily Operations in AWMS" chapter.

Procedure

Perform the following steps to deploy Aruba Configuration when at least one Aruba AP Group currently
exists on at least one Aruba controller on the network:
1. On the
This configuration defines optional group display options. This step is not critical to setup, and default
settings will support groups appropriate for Aruba Configuration. One important setting on this page is
Aruba GUI Config
the
24 | Aruba Configuration in AWMS
APs/Devices > Audit
Mismatched
Groups > Basic
page, enable device preferences for Aruba devices.
option. Ensure that setting is
page for device-specific auditing.
Import
from the
Licensing
link on the
on AWMS pages that reflect device configuration status.
"Related Documents" on page 7
Yes
, which is the default setting.
AirWave Wireless Management Suite | Configuration Guide
APs/Devices > Audit
page to reverse all of
APs/Devices > Monitor
Good
configuration will not result,
Figure 14 illustrates this page.
page.
for