Setting Event And Data Log File Parameters - Dell PowerEdge UPS 500T Installation And Configuration Manual

Setting Event and Data Log File Parameters

Use the Record Setting window to set the parameters for the log files. Select Record Setting from the
Logs menu. The Record Setting window opens (see Figure 45).
Figure 45. Record Setting Window
NOTE:
Clicking the Default button returns the parameters in this view to the default values. If the OK button is
disabled, the current Agent is read-only, and you cannot set up the parameters. You can log in as a Superuser
through the Act as Administrator menu.
Table 3 lists the log options and parameters.
Table 3. Log Options and Parameters
Parameter
Maximum File Length (Event Log)
Maximum File Length (Data Log)
Record Interval
The View Log buttons open the Event Log or Data Log. See "Viewing the Event Log" on page 41 or
"Viewing the Data Log" on page 42 for more information.
The Settings button opens the Event Action window. See the following section, "Configuring Event
Actions," for more information.
Unit Maximum Value
Rows 10,000
Rows 10,000
Seconds 3,600
Minimum Value Default Value
20
20
1
Configuring the Software
600
10,000
60
43