To change the SNMP port if the default Port 162 is occupied by other programs:
1 Select SNMP Port Setting from the SNMP menu.
2 Enter the new SNMP port and click OK (see Figure 103). The port range of the SNMP Port Settings is
1 to 65535, and the new port is immediately enabled.
Figure 103. SNMP Port Settings Confirmation Window
Rebooting Computers after a Utility Failure
You can reboot individual computers or all computers on the LAN automatically after a utility power
failure.
To configure the computers to reboot when the utility power restores:
1 Select Wake Up from the UPS menu to open the Wake on LAN window (see Figure 104).
Figure 104. Wake on LAN Window
Configuring the Software
94