C I/O Connection Specifications; Serial Port Cabling Pin Layout - HP StorageWorks MSA 2/8 - SAN Switch Installation Manual

I/O Connection Specifications
This appendix covers the following topics:
The serial port can be used to connect the switch to a computer workstation to
configure the switch IP address without connecting to the fabric. The serial port's
parameters are 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.
The port requires a straight serial cable with a female 9-pin subminiature-D
connector. Only pins 2, 3, and 5 are supported, as shown in Table 8.
Table 8: Serial Port Cabling Pin Layout
Note:
serial port and should be kept on the port whenever the serial port is not in use.
MSA SAN Switch 2/8 Installation Guide
The serial port can be used to connect the switch to a computer workstation to
configure the switch IP address without connecting to the fabric. The serial
port's parameters are 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow
control., page 67
Ethernet Port Specifications, page 68
Pin Signal
1 NC
2 TX
3 RX
4 NC
5 GND
6 NC
7 NC
8 NC
9 NC
For dust and ESD (electrostatic discharge) protection, a cover is provided for the
Description
Transmit data
Receive data
Ground
C
67