HP StorageWorks MSA 2/8 - SAN Switch Installation Manual page 28

Installing the MSA SAN Switch 2/8
Note:
each optical port and should be kept on the port whenever the port is not in use.
4. Connect the cables to the SFPs as appropriate to the fabric topology, by
5. Proceed to the following chapter in this guide to configure the MSA SAN
28
For dust and ESD (electrostatic discharge) protection, a cover is provided for
Caution: Do not connect the switch to a configured SAN without first
configuring the switch.
positioning each cable so that the key (the ridge on one side of the cable
connector) is aligned with the slot in the SFP.
Insert the cable into the SFP until it is firmly seated and the latching
mechanism clicks.
Switch for your SAN and verify its operation.
MSA SAN Switch 2/8 Installation Guide