Configuring the MSA SAN
Switch 2/8
The process of configuring the MSA SAN Switch includes the initial process of
changing the factory-set IP address to a valid IP address for your environment.
The IP address must initially be entered using the CLI.
After the IP address is set, additional parameters must be entered, but they may be
entered through either the CLI or the Web Tools.
This chapter discusses:
MSA SAN Switch 2/8 Installation Guide
Requirements, page 30
Entering Initial Configuration Settings through the
Connecting the MSA SAN Switch 2/8 to the Ethernet
Completing MSA SAN Switch 2/8
Verifying
Operation, page 36
CLI, page 31
Network, page 35
Configuration, page 36
3
29