Configuring the MSA SAN Switch 2/8
5. Establish a connection from the workstation to the switch using a terminal
6. Open the terminal connection to the switch, using HyperTerminal or
7. At the login prompt, enter the user ID. For example:
8. Enter the password for the user:
Note:
change the admin user ID and system password.
9. If the login was successful, a prompt is displayed showing the switch name
32
emulation application such as ProComm or Hyper Terminal.
In a Windows environment, enter the following settings:
Table 3: Serial Port Settings
Parameter
Bits per second
Databits
Parity
Stop bits
Flow control
In a Tru64 UNIX environment, enter the following command:
tip /dev/ttyb -9600
ProComm.
Press Enter several times to display the login prompt.
login: admin
The password prompt is displayed.
password: xxxxxx
The default password is password.
For security reasons, the first time you log into the CLI you are requested to
and user ID you are logged in as.
For example:
MSA1000-switch1:admin>
Value
9600
8
None
1
None
MSA SAN Switch 2/8 Installation Guide