Folder; E-Mail; Logout - Lexmark X642E - X642E Administrator's Manual

3 Using SafeCom Go Lexmark
3.5

Folder

Tap the Network Folder icon. Tap Start to scan and send the document to
folder. See also 2.5.9 Enable Send to Folder.
3.6

E-mail

Tap the E-mail icon. The To: field can be pre-filled with the User e-mail,
Blank or Default To: address. The From: field can be pre-filled with User e-
mail or Default From: address (see 2.5.10.) Tap each field and enter the
address using the keypad or touchscreen. Tap Start to scan and e-mail the
document.
3.7

Logout

There is a configurable Timeout that defaults to 60 seconds (2.4.2). The logout
process is initiated if no buttons are tapped for this period.
To logout:

Tap Logout.
o
o
o

Use card again (if a card reader is connected and you logged in by card).
Note: If Copy Control is enabled, the Logging out message is displayed until
the MFP is in an idle state. This allows correct reading of the MFP's copy page
counters.
D60711-14
On devices with SafeCom Go version 031xxx (1.2) there is a Logout
icon on the home screen and on the Document list. Tap to logout.
On devices with SafeCom Go version n21xxx (1.2) there is a small,
standard Lexmark Logout button with a yellow arrow in the top
right corner of the screen. Tap to logout.
On devices with SafeCom Go version 012xxx (1.2) there is a Logout
icon on the home screen. Tap to logout.
38