Safecom Go Lexmark - How To; Get The Safecom Go Lexmark Software; Specify Safecom Server - Lexmark X642E - X642E Administrator's Manual

2 SafeCom Go Lexmark
2.5

SafeCom Go Lexmark - How to

The following subsections contain step-by-step instructions for some of the
administrator's common tasks.
2.5.1

Get the SafeCom Go Lexmark software

The SafeCom Go Lexmark software files (*.fls) were installed from the SafeCom
CD or can be downloaded using the SafeCom Administrator function Check for
updates.
Alternatively a software package can be downloaded:
1. Download the safecom_go_lexmark_xxx.exe file from the link supplied to
you.
2. Double-click the safecom_go_lexmark_xxx.exe file.
3. Click Next.
4. Choose the destination folder. Click Next.
Normally the destination folder is:
C:\Program Files\SafeCom\SafeComG3\device_software
5. Click Install.
6. Click Finish.
2.5.2

Specify SafeCom Server

There are two ways to locate a SafeCom server:

manually

sending out a broadcast
To specify the SafeCom server manually
1. Go to the Configuration web page (2.4.2)
2. Enter Group Name, SafeCom server TCP port (default is 7500) and
SafeCom server IP address in Add.
3. Click Add.
4. In a multiserver solution, click Move up and Move down to prioritize the
order in which the servers are contacted in case the first one on the list
becomes unavailable.
Note: After you click Apply it takes approximately one minute before the new
SafeCom Server settings take effect. Wait, otherwise you may get a login error
at the printer.
To specify the SafeCom server by sending out a broadcast
1. Go to the Configuration web page (2.4.2)
D60711-14 24