Installation; Installing The Imaging Film - Sharp FO-1450 Operation Manual

INSTALLING THE IMAGING FILM
Take the new film out of its package, and
insert two of the gears provided with the
fax into the ends of the spool with film.
Make sure that the two tabs on the gears
fit properly into the slots in the ends of
the spool.
Do not yet remove the band which
holds the spools together.
5
Hold the empty spool so that the end
. '..
with only one slot is on the left, and
. . ~
lower the spools into the front of the print-
ing compartment. The gears in the ends
of the spool with film should fit into the
slots on each side of the printing com-
partment.
1
slot
'tL/~, 2 slots
\
2 tabs
Cut the band which holds the spools to-
gether with scissors, and remove it, In-
sert the remaining gear into the right end
of the empty spool and the flange into
the left end of the empty spool. Make
sure the tabs on the gear and the flange
fit into the slots in the ends of the spool
(the gear has two tabs and the flange
has one tab).
INSTALLATION 1-3