Table of Contents
Advertisement
INSTALLING THE IMAGING FILM
Take the new film out of its package,
and insert the three gears and the flange
into the ends of the spools as shown.
Make sure that the tabs on the gears
Gears and the flange fit properly into the slots
in the ends of the spools.
. © The flange has one tab, and the gears
3
each have 2 tabs.
e Do not yet remove the band which
holds the spools together.
Hold the empty spool so that the flange
is on the left, and lower the spools into
the front of the printing compartment so
that the gears in the ends of the spool
with the film fit into the slots on each
side of the printing compartment.
Cut the band which holds the spools to-
gether with scissors, and remove it.
INSTALLATION
1-3
Advertisement
Table of Contents
