Sharp FO-1450 Operation Manual page 59

MEMORY
4
START
Press the START key if you entered a
(
SDeedDial number or a full number,
M '
If the memory becomes full...
The document will be scanned and
stored in memory. Your fax will then
dial the receiving machine and trans-
mit the document (redialling will be
done automatically if necessary).
If the memory becomes full while the document is being scanned, MEMORY IS
FULL will appear in the display.
Press the START key if you want to transmit the pages which have been stored
up to that point in memory, The remaining pages will be ejected from the feeder.
After transmission, the memory will be cleared and you can transmit the
remaining pages, You will also need to transmit the page which was being
scanned when the memory filled up,
Press the STOP key if you want to cancel the entire transmission.
This is a back-up function which is automatically activated if your fax runs out of
paper, the printing ribbon needs replacement, or the paper jams.
When you have received a document in memofy, FAX RX IN MEMORY will appear
in the display, alternating with OUT OF PAPER, FILM END, or PAPER JAM. When
you add paper, replace the imaging film. or clear the jam, the stored documents will
automatically print out,
+ If you received documents in memory because the fax ran out of paper, be sure
to add paper which is the same size as the paper previously used, If not, the
document print-out size may not match the size of the printing paper.
Caution!
. When documents are stored in memory, do not turn the power off This will erase
all of the contents.
If documents received in memoty are lost due to a power failure or other
interruption of the power supply, a "CLEAR REPORT" will be printed out when
the power is restored, This gives information about the receptions lost, including
the fax numbers of the transmitting machines if they are available.
SPECIAL FUNCTIONS 5-3