Openvms Host-Based Volume Shadowing; Certified Third-Party Wdm, Ifcp, And Sonet Products; Xp Continuous Access Escon Ip Gateway Support - HP StorageWorks 4000/6000/8000 - Enterprise Virtual Arrays Reference Manual

Product and minimum
supported firmware
version
Brocade-McDATA-Inrange
9801 SNS
Firmware: 2.3 (Build 28)
or 2.4 (Build 13)
1
With McDATA-CNT Edge firmware 1.5.1 and B-series switches, ISL R_RDY mode = ON must be set on the E_Port of the switch (portcfgIS-
LMode = 1). For B-series switches using firmware 2.x, a remote switch license is required. E_D_TOV = 5,000, R_A_TOV = 10,000,
DataFieldSize = 2,048.
Table 178 XP Continuous Access ESCON IP gateway support
Configuration
XP Continuous Access ESCON over IP

OpenVMS host-based volume shadowing

HP supports the following HP and third-party devices and features for OpenVMS host-based volume
shadowing:
B-series1606 Extension SAN Switch and DC Dir Switch MP Extension Blade
400 MP Router, MP Router Blade
B-series FC and FCIP Fastwrite
Cisco PA-FC-1G
C-series MDS IP Storage Services Module (IPS-4, IPS-8)
Cisco MDS 14/2 Multiprotocol Services Module (including in MDS 9216i Fabric Channel switch
and gateway)
Cisco MDS 18/4 Multiservice Module (including the MDS 9222i Multiservice Fabric switch and
gateway)
C-series Write Acceleration
CNT UltraNet 1000
CNT UltraNet 1001
CNT UltraNet 3000
SR2122-2 IP Storage Router

Certified third-party WDM, iFCP, and SONET products

This section describes the following topics:
Certified third-party WDM
Certified third-party iFCP and SONET
352 SAN extension
XP storage system
XP1024
XP128
XP512
XP48
products, page 353
Supported switches: B-series 2400/2800, FC8B, and FC16B
Requires a remote switch license
Interoperability mode = 1, E_D_TOV = 5,000
Note: This converter has been discontinued. There is limited support for existing
installations.
Product and minimum supported firmware
version
McDATA-CNT Ultranet Storage Director (USD)
ESCON
Firmware: 2.6.2-0 or 3.1
products, page 353
Notes
Minimum IP bandwidth per
path
100 Mb/s