Wdm Overview; Wdm Network Implementation; Wdm System Architectures - HP StorageWorks 4000/6000/8000 - Enterprise Virtual Arrays Reference Manual

WDM system
HP coarse wave division
Third-party WDM

WDM overview

WDM devices extend the distance between two Fibre Channel switches. The devices are transparent
to the switches and do not count as an additional hop.
To accommodate WDM devices, you must have enough Fibre Channel BB_credits to maintain line-speed
performance. WDM supports Fibre Channel speeds of 4 Gb/s, 2 Gb/s, and 1 Gb/s. When planning
SAN extension, BB_credits are an important consideration in WDM network configurations. Typical
WDM implementations for storage replication include a primary and secondary path. You must have
enough BB_credits to cover the distances for both the primary path and secondary path so that
performance is not affected if the primary path fails.

WDM network implementation

WDM-based networks provide a lower-cost way to respond quickly to increased bandwidth demands
and protocol changes. The quick response occurs because each wavelength is a new, full-bandwidth
communications link. In many areas of the world, it is less expensive to deploy WDM devices on
existing fiber than it is to install new fiber.
After implementing WDM, service providers can establish a "grow as you go" infrastructure. Service
providers can expand capacity in any portion of their networks. Carriers can address areas of
congestion resulting from high-capacity demands.
WDM enables you to partition and maintain dedicated wavelengths for different customers. For
example, service providers can lease wavelengths (instead of an entire fiber) to their high-use business
customers.

WDM system architectures

The WDM system architectures are as follows:
Passive (optical transmission protocol)
Active signal amplification
Active protocol handling
Most WDM products use one of these architectures or combine attributes of each.
Table 140 summarizes the WDM system architectures.
Table 140 WDM system architectures
System architecture
Passive (optical transmission protocol)
284 SAN extension
characteristics, page 285
multiplexing, page 285
products, page 286
1
Transparent to transmission protocol and data-rate independent
Establishes open interfaces that provide flexibility to use Fibre Channel, SONET/SDH,
ATM, Frame Relay, and other protocols over the same fiber
Passes the optical signal without any form of signal conditioning such as amplification
or attenuation
Description