Xp Continuous Access Fcip Configuration - HP StorageWorks 4000/6000/8000 - Enterprise Virtual Arrays Reference Manual

XP storage
Configuration
system
Fibre Channel XP24000
XP20000
XP12000
Distance is unlimited using converters and Asynchronous replication.
Converter and Synchronous replication have practical distance limitations.
Supported distance for an ATM connection depends on network latency delays, packet loss, and application performance
nl
requirements.
1
Cisco FCMR-4 only
FCIP and routing extension
This section describes the XP Continuous Access data replication IP specifications and the supported
minimum and maximum transmission rates for qualified switch and IP gateway pairs.
Figure 124 and
RCU
I
Figure 124 XP Continuous Access FCIP configuration
.
346 SAN extension
nl
Ciena CN 2000 for FC over SONET/SDH or DWDM. See
Requirements:
Firmware 5.1.0, 5.0.1
SONET/SDH OC-3
Port parameters:
For direct connect, Fabric = Off, Connection = FC-AL
For switch/fabric connect (B-series switches), Fabric = On, Connection = Point to Point
Figure 125 show XP Continuous Access FCIP and iFCP configurations.
FCIP
IP LAN/WAN
FCIP
Supported bandwidths and products
Distances
FCIP
Figure 123.
I
RCU
25330a