B-Series Mp Router Features And Requirements - HP StorageWorks 4000/6000/8000 - Enterprise Virtual Arrays Reference Manual

B-series MP Router features and requirements

Table 152 lists the features and requirements for the MP Router.
Table 152 B-series MP Router features and requirements
Feature
Switches for iSCSI and FCIP
IP network protocols
Storage systems
FCIP-supported operating systems
Documentation
320 SAN extension
The MP Router is supported with the B-series switches listed in
fabric rules" on page 93. The MP Router is not supported for use as a Fibre Channel
switch. Direct device connectivity to MP Router ports (F_Ports) is supported only with
iSCSI (see "iSCSI storage" on page 355).
TCP/IP IPv4, Ethernet 10 Mb/s, 100 Mb/s, and 1,000 Mb/s
Requires dedicated IP bandwidth, see
Note: You can only use optical GbE compatible connections to the FCIP or iSCSI ports.
Continuous Access EVA
Continuous Access XP20000/24000, XP10000/12000, XP128/1024, XP48/512
See "Heterogeneous server
Note: B-series MP Router ports used for Continuous Access EVA must have the
exchange-based routing feature disabled. Use the following command to disable
exchange-based routing across FCIP port processors:
portCfgFcip -m 2
FCIP portcfgfcip [-m LOAD_BAL (1-exchange, 2-SID_DID, 3-none]
The default is 1. You must set this value to 2 or 3 for Continuous Access EVA.
XP Continuous Access supports exchange-based routing, SID-DID, or none.
For Continuous Access EVA, see the HP StorageWorks Enterprise Virtual Array
compatibility reference matrix at
software/conaccesseva/index.html.
For information about the MP Router, see the MP Router website:
http://h18006.www1.hp.com/products/storageworks/mprouter/index.html
Requirements
Table 157 and Table
rules" on page 185 for operating system support.
http://h18006.www1.hp.com/products/storage/
"B-series switches and
161.