Intergraph InterServe 05 Setup Manual page 53

40
4. Use the arrow keys or the mouse to select Step 2 from the SCU Main Menu. Then press
INSERT
A prompt displays requesting you to copy the configuration files needed to configure the
system. The configuration file is on a diskette provided by the ISA board manufacturer.
5. Press
ENTER
6. Select the slot where the board will be installed. Only slots 1 through 4 are valid for the
system.
When prompted to insert the source disk, insert the diskette containing the configuration
file and press
7. When prompted to insert the destination disk, insert the SYSUTIL diskette and press
ENTER
system and to the SYSUTIL diskette.
8. Press
ESC
9. Select Step 4 to save the configuration, and then select Step 6 to exit the SCU.
10. Remove the diskette from the floppy disk drive and restart the system.
ISA Boards without a Configuration File
Some ISA board vendors do not include configuration files with their boards. For these
boards, you must use the SCU to define the ISA board to the system.
To configure ISA boards without a configuration file:
1. Shut down and power off the system.
2. Insert the SYSUTIL diskette into the floppy disk drive; then restart the system.
3. When the MS-DOS Startup menu displays, select option 1 to run the SCU.
to add a board that was not detected or has not been installed.
to accept :\ as the path to the configuration file.
A
.
ENTER
. The configuration file from the option board manufacturer will be installed to the
to return to the SCU Main Menu.