Table of Contents
Advertisement
6
6.
Go to "Preparing for Windows NT Setup" later in this chapter.
Installing an External SCSI Device
To install an external SCSI device:
1.
Set the device's SCSI ID to an unused number and enable or disable the device's SCSI
termination according to the vendor's instructions.
2.
Connect one end of the SCSI cable to the SCSI port on the back of the base unit. If other
external devices are installed, connect the SCSI cable to the available SCSI port on the
last device on the SCSI cable chain.
NOTE
Make sure the last device on the chain of external SCSI devices has a SCSI terminator
attached to the open SCSI port.
Slot 6
Slot 5
Slot 4
Slot 3
Slot 2
Slot 1
Latching
Clips
Advertisement
Table of Contents
Need help?
Do you have a question about the InterServe 05 and is the answer not in the manual?
Questions and answers