Intergraph InterServe 05 Setup Manual page 54

4. From the SCU Main Menu, select Step 2, then press
displays as shown in the following figure.
5. Enter the data specified in the manufacturer's configuration instructions.
NOTE Use the
TAB
and Ports fields, press
6. Press
F
7. Press
ENTER
8. Press
ESC
9. Select Step 2. The Add and Remove Boards Menu displays.
10. Select the required slot number and press
11. Select
12. Select the correct board name and press
13. When the Slot Selection Menu displays, select the required slot and press
14. Press
ESC
15. Select Step 4 to save the configuration.
16. Select Step 6 to exit the SCU.
17. Remove the diskette from the floppy disk drive; then restart the system.
and arrow keys to move the cursor from field to field. Once inside the DMA, IRQ,
to display the sub-fields for entering the information.
ENTER
10 to save the data to the system.
to return to the ISA Board Definition Menu.
to return to the SCU Main Menu.
again to add the board. The ISA Board Database Menu displays.
INSERT
to return to the SCU Main Menu.
6. The ISA Board Definition Menu
F
.
INSERT
.
ENTER
41
.
ENTER