Table of Contents
Advertisement
Headstock Faceplate
Installing Faceplate
To install faceplate:
1.
DISCONNECT MACHINE FROM POWER!
2.
Insert indexing pin into an indexing hole and
rotate spindle until pin engages to prevent
spindle from turning while you tighten face-
plate, as shown in Figure 23.
Faceplate Set
Screw (1 of 2)
Figure 23. Locking spindle with indexing pin and
faceplate set screw.
3.
Thread faceplate onto spindle until it is snug.
4.
Using included 4mm hex wrench, tighten two
set screws along inside diameter of faceplate
to secure it to spindle (see Figure 23).
To prevent faceplate and workpiece sepa-
rating from spindle during operation, head-
stock faceplate MUST be firmly threaded
onto spindle and secured in place by fully
tightening the two faceplate set screws.
If these instructions are not properly per-
formed, serious personal injury could occur.
Note: To remove faceplate, disconnect lathe from
power source and perform steps above in reverse.
-26-
Indexing Pin
Changing Speed Ranges
Changing Speed
Ranges
The Model G0766 pulley belt configurations pro-
vide two speed ranges (see Figure 24).
A
= High Range
330-3200 RPM
= Low Range
B
100-1200 RPM
Motor
Figure 24. Speed range belt positions.
Note: To maximize spindle torque, use low spin-
dle speed range for spindle speeds of 1200 RPM
or less.
Refer to speed recommendations chart in Figure
25 to choose appropriate RPM for your opera-
tion. Then choose speed range that will include
selected RPM.
Diameter
Roughing
of Work-
RPM
piece
Under 2"
1520
2–4"
760
4–6"
510
6–8"
380
8–10"
300
10–12"
255
12–14"
220
14–16"
190
Figure 25. Model G0766 speed
recommendations.
Model G0766 (Mfd. Since 11/17)
Spindle
A
B
General
Finishing
Cutting
RPM
RPM
3200
3200
1600
2480
1080
1650
810
1240
650
1000
540
830
460
710
400
620
Advertisement
Table of Contents
