Usb Board/Dc-In Jack/Network Jack - Toshiba SATELLITE M30-35 Series Maintenance Manual

4 Replacement Procedures

4.22 USB Board/DC-IN jack/Network jack

Removing the USB Board/DC-IN jack/Network jack
To remove the USB board/DC-IN jack/network jack, follow the steps below and refer to
figure 4-34.
1. Remove the following screw securing the USB board.
• M2.5×4B FLAT HEAD screw
2. Disconnect the USB cable from the connector CN1 on the USB board.
3. Peel off the acetate tape and remove the network jack from the slot.
4. Disconnect the DC-IN jack cable from the connector CN1 on the power board and
remove the DC-IN jack.
Acetate tape
Figure 4-34 Removing the USB board/DC-IN jack/network jack
4-56
DC-IN jack
Network jack
4.22 USB Board/DC-IN jack/Network jack
×1
M2.5×4B FLAT HEAD
USB board
Satellite M30-35 Maintenance Manual (960-455)
USB cable