Programming Example With 730 Module Installed - Teledyne 6712FR Installation And Operation Manual

Table 4-4 Programming Example With 730 Module Installed
MODULE INSERTED---
DOWNLOAD DATA NOW
OR LOSE ALL DATA!
1
DONE
6712 SAMPLER
STANDARD PROGRAMMING
2
For HELP at any
screen press ? key.
RUN
PROGRAM
3
VIEW REPORT
OTHER FUNCTIONS
SITE DESCRIPTION:
"FACTORY051"
4
CHANGE?
YES NO
SELECT UNITS FOR
FLOW RATE:
cfs gps gpm Mgd
5
lps m3s m3h m3d
SELECT UNITS FOR
FLOW VOLUME:
6
cf gal Mgal
m3 lit
PROGRAM MODULE?
7
YES NO
MODE OF OPERATION:
FLOWMETER
8
LEVEL ONLY
WEIR FLUME
DATA POINTS
9
EQUATION MANNING
FLOW-INSERT
Most Isco accessories and interfacing equipment are not certi-
fied for us in hazardous locations as defined by the National
Electrical Code. Check applicable guidelines, codes, and regu-
lations of federal, state, city, and county agencies. Refer to
Appendix C in the back of this manual for more safety informa-
tion.
With the sampler off, insert the module in the bay on the controller.
Turn the sampler on by pressing the
Download stored data, if you want to keep it. Pressing DONE erases it and
advances to the next screen.
This screen will now appear for 8 seconds.
The option PROGRAM will be blinking. Press
The option NO will be blinking. Press
For the purposes of this example, it isn't necessary to change the description.
Select the desired units for the flow rate. For this example, choose cfs.
↵
Press .
Select the desired units for the flow volume. For this example, choose Mgal.
↵
Press .
Select YES to program the module.
If you choose Flowmeter, proceed to screen #9 below.
If you choose LEVEL ONLY, proceed to screen #12.
When you select Flowmeter, you will have several options for performing the
flow conversion.
For this example, choose Weir. Press
6712FR Refrigerated Sampler
Section 4 Standard Programming
CAUTION
↵
On/Off
key. Press .
↵
.
↵
.
↵
.
4-29