Teledyne 6712FR Installation And Operation Manual page 88

6712FR Refrigerated Sampler
Section 4 Standard Programming
Table 4-5 Programming Example With 750 Module Installed (Continued)
PROGRAM MODULE?
8
YES NO
MODE OF OPERATION:
FLOWMETER
9
LEVEL AND VELOCITY
FLOW CALCULATION:
AREA * VELOCITY
10
LEVEL TO FLOW RATE
LEVEL TO AREA:
CHANNEL SHAPE
11
DATA POINTS
ROUND PIPE
U-CHANNEL
12
RECTANGULAR CHANNEL
TRAPEZOIDAL CHANNEL
ROUND PIPE
13
DIAMETER = 2.00 ft
CURRENT LEVEL IS
__.__ ft
14
ADJUST LEVEL TO
__.__ ft
ZERO LEVEL OFFSET:
15
_.___ ft
MAXIMUM DEPTH FOR
VELOCITY MEASUREMENT
16
2" 3" 4"
NUMBER OF BOTTLES:
17
1 2 4 8 12 24
4-32
Select YES to program the module.
The 750 can have two different modes of operation: Flowmeter or Level and
Velocity.
For this example, choose Flowmeter. Press
When you select Flowmeter, you will have two options for performing the
flow conversion: Area * Velocity or Level to Flow Rate.
For this example, choose Area * Velocity. Press
For this example, choose Channel Shape. Press
For the channel shape, select Round Pipe. Press
Enter the diameter of the round pipe. Press
The current level will be displayed. Enter an adjustment if needed. If the
adjustment is different by more than 0.50 ft, you will be prompted "
? " Choose
SURE YES NO NO
Enter the amount of zero level offset. Press
(This screen is applicable for standard-sized probes only.)
Select the maximum depth for the velocity measurement. Press
Select the number of bottles in your bottle kit by pressing either arrow key
until the correct number blinks. Press
From this point forward, the screens will be the same as in Table 4-2.
↵
.
↵
.
↵
.
↵
.
↵
.
to re-enter; select if correct. Press
YES
↵
.
↵
.
ARE YOU
↵
.
↵
.