Teledyne 6712FR Installation And Operation Manual page 126

6712FR Refrigerated Sampler
Section 5 Extended Programming
Although the screens displayed may vary depending on
your site setup, the programming sequence will be the
same or similar to the following example.
1. Select
OTHER FUNCTIONS
alarm.
RUN "EXTENDED 1"
PROGRAM
VIEW REPORT
OTHER FUNCTIONS
2. Select hardware and use the down arrow to scroll
to the I/O screen.
MAINTENANCE
MANUAL FUNCTIONS
SOFTWARE OPTIONS
HARDWARE
↑
I/O1 = NONE
I/O2 = NONE
I/O3 = NONE
3. Select the first pin to program.
SET I/O1:
From this screen, your choices are viewed by
scrolling with the arrow buttons:
PGM RUNNING
PGM ENABLED
' '
A ENABLED
' '
B ENABLED
PROGRAM DONE
' '
A
' '
B
RUN ERROR
FLOW
CONDITIONS
NONE
/
I O ENABLE
5-38
Example: I/O Pin Programming
to enable the dialout
↓
DONE
DONE
-
THRU
Note: All choices listed are alarm output settings,
except for / . This is the input function to
I O ENABLE
enable the sampler via an external device.
4. If you select
CONDITIONS
I/O1:
RAIN
Depending on what equipment is connected to your
sampler, you may see other parameters in addition to
, such as ,
RAIN LEVEL FLOW
, you can program limits for a condition to
CONDITIONS
trigger the alarm when the measured parameter
exceeds its limit. You can use one or two conditions to
trigger one alarm, using AND or OR operators.
5. When you select a parameter with the arrow keys
and Enter, you can then program the limits for
alarm triggering. For example, if you select rain,
the sampler will display:
"RAIN" SET POINT:
1.00 INCHES PER
1 HOURS,
I/O IS HIGH WHEN:
ABOVE SET POINT
BELOW SET POINT
" / " means "Alarm is triggered." Select
I O IS HIGH
or , then select whether or not to reset
ABOVE BELOW
rainfall history when the alarm is triggered:
RESET RAIN HISTORY?
YES
Continue with programming I/O2 and I/O3 in the same
manner, or if additional alarms are not needed, select
.
NONE
, the sampler will display:
NONE
, , etc. Under
VELOCITY
0 MINUTES
NO